Jump to content
Как правильно добавить self-test и прочую отладку в тему
Где взять тестовые сборки
Официальное хранилище ПО в виде файлов
  • 0

50A4/50A3 - один из двух WG (public) каналов не поднимается автоматом после перезагрузки роутера

vasek00

Asked by vasek00,

 Share

Question

vasek00 Honored Flooder

vasek00

Posted
Posted (edited)

50A4/50A3 - один из двух WG (public) каналов не поднимается автоматом после перезагрузки роутера. 

via interface is not ready, standby

Не готовность интерфейса vlan9 к моменту запуска WG1. Два канала - PPPoE0/WAN порт для WG0 и Vlan9/LAN порт под WAN для WG1.

Спойлер 
interface Wireguard1
    description P...
    dyndns nobind
    security-level public
    ip address 10.11.130.96 255.255.255.255
    ip mtu 1324
    ip access-group _WEBADMIN_Wireguard1 in
    ip global 65377
    ip tcp adjust-mss pmtu
    wireguard listen-port 65106
    wireguard asc 1 .....
    wireguard peer nw5.....k= !WG-P...
        endpoint 111.111.111.111:5060
        keepalive-interval 60
        allow-ips 0.0.0.0 0.0.0.0
        allow-ips 192.168.130.0 255.255.255.0
        allow-ips 10.11.130.96 255.255.255.255
        connect via GigabitEthernet0/Vlan9
    !

interface GigabitEthernet0/Vlan9
    description Inet-2
    dyndns nobind
    security-level public
...
up

[I] Jun 22 10:30:47 ndm: Network::Interface::Base: "Wireguard1": interface is down. 
[I] Jun 22 10:30:47 ndm: Network::Interface::Base: "Wireguard1": "l3-base" changed "ctrl" layer state "invalid" to "running". 
[I] Jun 22 10:30:47 ndm: Network::Interface::Base: "Wireguard1": network MTU reset to default. 
[I] Jun 22 10:30:47 ndm: Network::Interface::Base: "Wireguard1": "wireguard" changed "link" layer state "invalid" to "disabled". 
[I] Jun 22 10:30:47 ndm: Network::Interface::Repository: "Wireguard1" interface created. 

[I] Jun 22 10:30:47 ndm: Network::Interface::Base: "Wireguard1": description saved. 
[I] Jun 22 10:30:47 ndm: DynDns::Client: disabled bind on interface Wireguard1. 
[I] Jun 22 10:30:47 ndm: Network::Interface::L3Base: "Wireguard1": security level set to "public". 
[I] Jun 22 10:30:47 ndm: Network::Interface::Ip: "Wireguard1": IP address is 10.11.130.96/32. 
[I] Jun 22 10:30:47 ndm: Network::Interface::Base: "Wireguard1": static MTU is 1324. 
[I] Jun 22 10:30:47 ndm: Network::Acl: input "_WEBADMIN_Wireguard1" access list added to "Wireguard1". 
[I] Jun 22 10:30:47 ndm: Network::Interface::L3Base: "Wireguard1": global priority is 65377. 
[I] Jun 22 10:30:47 ndm: Network::Interface::Ip: "Wireguard1": TCP-MSS adjustment enabled. 
[I] Jun 22 10:30:47 ndm: Wireguard::Interface: "Wireguard1": set listen port to "65106". 
[I] Jun 22 10:30:47 ndm: Wireguard::Interface: "Wireguard1": set ASC parameters. 
[I] Jun 22 10:30:47 ndm: Wireguard::Interface: "Wireguard1": created peer "nw......................................ik=". 
[I] Jun 22 10:30:47 kernel: wireguard: Wireguard1: peer "nw......................................ik=" (2) created
[I] Jun 22 10:30:47 ndm: Wireguard::Interface: "Wireguard1": set peer "nw......................................ik=" endpoint to "111.111.111.111:5060". 
[I] Jun 22 10:30:47 ndm: Wireguard::Interface: "Wireguard1": set peer "nw......................................ik=" keepalive interval to "60". 
[I] Jun 22 10:30:47 ndm: Wireguard::Interface: "Wireguard1": add allowed IPs "0.0.0.0/0.0.0.0" from peer "nw......................................ik=". 
[I] Jun 22 10:30:47 ndm: Wireguard::Interface: "Wireguard1": add allowed IPs "192.168.130.0/255.255.255.0" from peer "nw......................................ik=". 
[I] Jun 22 10:30:47 ndm: Wireguard::Interface: "Wireguard1": add allowed IPs "10.11.130.96/255.255.255.255" from peer "nw......................................ik=". 
[E] Jun 22 10:30:47 ndm: Network::Interface::Ip: "GigabitEthernet0/Vlan9": address is not available. 
[I] Jun 22 10:30:47 ndm: Wireguard::Interface: "Wireguard1": set peer "nw......................................ik=" connect via "GigabitEthernet0/Vlan9". 
[I] Jun 22 10:30:47 ndm: Network::Interface::Base: "Wireguard1": "base" changed "conf" layer state "disabled" to "running". 
[I] Jun 22 10:30:47 ndm: Network::Interface::Base: "Wireguard1": interface is up. 

[I] Jun 22 10:30:48 ndm: Wireguard::Interface: "Wireguard1": resolved peer "nw......................................ik=" endpoint to "111.111.111.111. 
[I] Jun 22 10:30:48 kernel: wireguard: Wireguard1: peer "nw......................................ik=" (2) (0.0.0.0:5060) destroyed
[I] Jun 22 10:30:48 ndm: Wireguard::Interface: "Wireguard1": "nw......................................ik=": via interface is not ready, standby. 

[I] Jun 22 10:30:49 pppd[872]: PPP session is 16472 
[I] Jun 22 10:30:49 pppd[872]: Using interface ppp0 
[I] Jun 22 10:30:49 pppd[872]: Connect: ppp0 <--> eth3 
[I] Jun 22 10:30:49 pppd[872]: CHAP authentication succeeded: Authentication success,Welcome! 
[I] Jun 22 10:30:49 pppd[872]: CHAP authentication succeeded 
...
[I] Jun 22 10:30:49 pppd[872]: local  IP address xxx.xxx.xxx.30 
[I] Jun 22 10:30:49 pppd[872]: remote IP address xxx.xxx.0.1 
...
[I] Jun 22 10:30:52 ndm: Network::Interface::Mtk::Ppe: software PPE enabled. 
[I] Jun 22 10:30:52 ndm: Network::Interface::Mtk::Ppe: hardware PPE enabled. 
...
[I] Jun 22 10:30:52 ndhcpc: GigabitEthernet0/Vlan9: received ACK for 10.10.10.12 from 10.10.10.200 lease 1200 sec. 
[I] Jun 22 10:30:52 ndm: Dhcp::Client: configuring interface GigabitEthernet0/Vlan9. 
[I] Jun 22 10:30:52 ndm: Network::Interface::Ip: "GigabitEthernet0/Vlan9": IP address is 10.10.10.12/24. 
[I] Jun 22 10:30:52 ndm: Dhcp::Client: obtained IP address 10.10.10.12/24. 
[I] Jun 22 10:30:52 ndm: Dhcp::Client: interface "GigabitEthernet0/Vlan9" is global, priority 65460. 
[I] Jun 22 10:30:52 ndm: Dhcp::Client: adding a default route via 10.10.10.1. 
[I] Jun 22 10:30:52 ndm: Network::Interface::Base: "GigabitEthernet0/Vlan9": "dhcp-client" changed "ipv4" layer state "pending" to "running". 
...
[I] Jun 22 10:30:55 ndm: Network::Interface::EndpointTracker: "Wireguard0": ".....................................=": connecting via "PPPoE0" (PPPoE0). 
[I] Jun 22 10:30:55 ndm: Network::Interface::EndpointTracker: "Wireguard0": ".....................................=": local endpoint is "xxx.xxx.xxx.30". 
[I] Jun 22 10:30:55 kernel: wireguard: Wireguard0: peer "...............................................=" (7) created
[I] Jun 22 10:30:55 ndm: Wireguard::Interface: "Wireguard1": resolved peer "nw......................................ik=" endpoint to "111.111.111.111". 
[I] Jun 22 10:30:55 ndm: Wireguard::Interface: "Wireguard1": "nw......................................ik=": via interface is not ready, standby. 
[I] Jun 22 10:30:55 kernel: usb 2-1: New USB device found, idVendor=0bda, idProduct=9210, bcdDevice=f0.01
[I] Jun 22 10:30:55 kernel: usb 2-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[I] Jun 22 10:30:55 kernel: usb 2-1: Product: RTL9210B-CG
[I] Jun 22 10:30:55 kernel: usb 2-1: Manufacturer: Realtek
...

 

 

  

Передергивание 
[I] Jun 22 15:51:26 ndm: Network::Interface::Base: "Wireguard1": "base" changed "conf" layer state "running" to "disabled". 
[I] Jun 22 15:51:26 ndm: Network::Interface::Base: "Wireguard1": interface is down. 
[I] Jun 22 15:51:26 ndm: Core::System::StartupConfig: saving (http/rci). 
[I] Jun 22 15:51:28 ndm: Network::Interface::Base: "Wireguard1": "base" changed "conf" layer state "disabled" to "running". 
[I] Jun 22 15:51:28 ndm: Network::Interface::Base: "Wireguard1": interface is up. 
[I] Jun 22 15:51:28 ndm: Core::System::StartupConfig: saving (http/rci). 
[I] Jun 22 15:51:30 kernel: wireguard: Wireguard1: peer "nw....................................ik=" (9) created
[I] Jun 22 15:51:30 ndm: Wireguard::Interface: "Wireguard1": resolved peer "nw....................................ik=" endpoint to "111.111.111.111". 
[I] Jun 22 15:51:30 ndm: Network::Interface::EndpointTracker: "Wireguard1": "nw....................................ik=": remote endpoint is "111.111.111.111". 
[I] Jun 22 15:51:30 ndm: Network::Interface::EndpointTracker: "Wireguard1": "nw....................................ik=": connecting via "GigabitEthernet0/Vlan9" (GigabitEthernet0/Vlan9). 
[I] Jun 22 15:51:30 ndm: Network::Interface::EndpointTracker: "Wireguard1": "nw....................................ik=": local endpoint is "10.10.10.12". 
[I] Jun 22 15:51:30 ndm: Core::System::StartupConfig: configuration saved. 
[I] Jun 22 15:51:32 ndm: Network::Interface::Base: "Wireguard1": "wireguard" changed "link" layer state "pending" to "running". 
[I] Jun 22 15:51:32 ndm: Network::Interface::Ip: "Wireguard1": interface "Wireguard1" is global, priority 65377. 
[I] Jun 22 15:51:32 ndm: Network::Interface::Ip: "Wireguard1": adding default route via Wireguard1. 
[I] Jun 22 15:51:32 ndm: Network::Interface::Ip6: "Wireguard1": interface "Wireguard1" is global, priority 65377. 
[I] Jun 22 15:51:32 ndm: Network::Interface::Ip6: "Wireguard1": adding default route via Wireguard1.

 

 

 

Edited by vasek00

0 answers to this question

Recommended Posts

There have been no answers to this question yet

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Answer this question...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to question listing

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

This site uses cookies. By clicking "I accept" or continuing to browse the site, you authorize their use in accordance with the Privacy Policy.

  I accept