Jump to content

fl4co

Forum Members
  • Posts

    41
  • Joined

  • Last visited

Equipment

  • Keenetic
    Skipper

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

fl4co's Achievements

Member

Member (2/5)

13

Reputation

  1. With Alpha 12 the new component is present on the Skipper.
  2. Italy. I think Skipper is the European name for the model KN-1910.
  3. Then I don't have it 🤷‍♀️
  4. I don't have it. Do I need to remove "traffic shaper" first?
  5. Hello, I'm in version 3.7 Alpha 11 but I can't find the component to install. I searched for "ntce" and "traffic analizer" but didn't find anything, How is the component called?
  6. Thank you for clearing this out. Now the the wg interface doesn't do NAT anymore as I intended. What does doing no ip nat Home imply, anyway? If I create a L2TP VPN then I will have to manually add ip static Home <l2tp interface> to be able to access the Internet through the tunnel?
  7. Hello, I recently bought a Keenetic Skipper router and I’m very pleased with it.However, there is one problem I can’t seem to be able to fix: I set up a WireGuard connection but I can’t disable NAT translation on the interface. When I connect to a WireGuard peer from a device behind the Skipper, the peer always sees the connection originating from the the Skipper’s WireGuard address and not from the actual device’s IP address.I tried entering the command “no ip nat Wireguard0” but it has no effect because I think that a NAT rule was not active on the interface to begin with.So how can I disable NAT on the WireGuard interface?
×
×
  • Create New...

Important Information

This site uses cookies. By clicking "I accept" or continuing to browse the site, you authorize their use in accordance with the Privacy Policy.